由于电蒸汽锅炉http://www.jnshengxin.cn/等大型锅炉一般用于工业生产或者是工业用水的热交换设备，体积一般比家用蒸汽锅炉体积较大，所以在安装过程中掌握平衡的问题就摆在了用户的面前，那么蒸汽锅炉在安装过程中如何掌握平衡?
大型蒸汽锅炉在安装过程中保持左右平衡的方法可以从纵向、横向两方面入手，轻松帮您的蒸汽锅炉找平。
Large steam boiler maintain about balancing methods during the installation process from vertical, horizontal two-pronged approach to help you easily steam boiler leveling.
电蒸汽锅炉http://www.jnshengxin.cn/在南北方向找平的方法：先找到水平尺长不小于600毫米的尺子，将尺子水平放在蒸汽锅炉炉排的纵排面上，治愈炉排前后两处，要求炉排面纵向应水平或炉排面略坡向炉膛后部这样可以很轻松的检查到炉排面的纵向水平度。最大倾斜度小于等于10毫米.当蒸汽锅炉纵向不平时，可用千斤顶将过低的一端顶起，在蒸汽锅炉的支架下垫以适当厚度的钢板，使蒸汽锅炉的水平度达到要求。垫铁的间距一般为500～1000mm。
Electric steam boiler in north-south direction leveling approach: first find a ruler-foot level of not less than 600 mm long, and the ruler placed horizontally on a vertical surface of a steam boiler drain grate, grate heal around two, require longitudinal grate surface should horizontal or grate furnace rear surface slope slightly so you can easily check the level of the grate longitudinal plane. The maximum gradient of 10 mm or less. When the steam boiler is not the usual portrait, can jack the low end of the top, in the steam boiler underlying stent to the proper thickness steel plate, so that the level of the steam boilers meet the requirements. Pitch horn is generally 500 ~ 1000mm.
电蒸汽锅炉http://www.jnshengxin.cn/在东西方向找平的方法：先找到水平尺长不小于600毫米的尺子，将尺子水平放在蒸汽锅炉炉排的横排面上，治愈炉排前后两处，炉排的横向倾斜度不得大于5mm(炉排的横向倾斜过大会导致炉排跑偏)。当炉排横向不平时，用千斤顶将蒸汽锅炉一侧支架同时顶起，在支架下垫以适当厚度的钢板，垫铁的间距一般为500～1000mm。
Electric steam boilers in east-west direction leveling approach: first find a ruler-foot level of not less than 600 mm long, and the horizontal ruler placed horizontally on the surface of a steam boiler grate, cure around the grate two lateral inclination grate no larger than 5mm (lateral tilting grate grate over the General Assembly lead to deviation). When the grate laterally peacetime,the steam boiler with a jack from the top side of the bracket at the same time, the underlying stent to the proper thickness steel plate, horn spacing is generally 500 ~ 1000mm.
